Raail AirWrap 2K Gloss
2k gloss
1.3-1.5 Tip size
PSI 10-15 compressor
Stage 3 Turbine Friendly Gloss
How to
-After you spray your Raail AirWrap allow 1-2 hours to dry.
Turbine users: make sure your turbine is not running hot. Stage 3 turbine works best. Stage 5 is too much power and over heats.
Spraying the air and ground with water will help keep trash down and off the car. Not puddles. Just wetting the ground a little. The goal is to have a clean surface to spray the gloss in.
SHAKE THE GLOSS AND ACTIVATOR!!!!
GLOSS AND ACTIVATOR MUST BE ROOM TEMPERATURE. WE DONT KEEP OURS IN THE GARAGE.
4:1
4 part gloss, 1 part activator.
-Only mix what you need. Don't mix the entire gallon of gloss and activator at once. (It will harden over time)
-Do a test fender first.
-Spray one panel at a time.
-First coat should be medium wet. Not dusting but not wet.
-Wait 10 min and spray another wet coat.
-Allow 3-4 hours to cure.
*YOUR GUN MUST BE 100% CLEAN BEFORE SPRAYING THE GLOSS
**Keep your 2k gloss in cool room temperature till it's time to spray
2/3 of a Gallon will do an average size sedan.
1 Gallon will do an average size truck/SUV